Program ademco remote 5804

In addition, each of the four buttons can be custom programmed to your needs. When programming the E keyfob, each unit is assigned a unique serial number during manufacture.

Each button on the unit also has a distinct "loop" number that you must program into the control panel during installation. When you are prompted for the serial number, either press and release twice the button you are programming, or enter it manually through the keypad. The E is a compact, 4-button portable wireless transmitter intended for use only with wireless alarm systems that support Series receivers. Each button on the transmitter may be programmed for any zone response, but is typically used for arming, disarming, panic, and relay activation.

By pressing two keys in unison a panic alarm signal will be sent. If P rogra mming 4E in the Co ntrol. Program the button in the control. Af ter pr ogra mming is compl ete , exit. Press all 4 buttons on the E at the same. T o sync the devi ce in High Secu rity Mode ,. Figu re 1: E showin g butt on design ations.

Hold all 4 buttons dow n w hile enrolling the serial. Enroll the 4E into the re ceivers one at a ti me,. Then , disconnect Re ceiver 1, reconnec t. Receiver 2 , and repeat the enrollment procedure. This proces s ensures proper High Se curity. The E is suppl ied with colored but tons red. Each label has. To paste a label on a butt on, slow ly peel off a. If you dec ide later to re-. Additional color ed buttons red and blue are a lso.